"Close Gap" automatically closes gaps in the lines. Or remove the points by dragging them out of the graph. You can add as many control points in the graph as you want by just clicking right into it. The "Output Settings" pre-determine how the gradients are drawn. "Black" and "Transparent color" can normally be left at their default settings. Now let's talk shortly about the settings of that tool. So, as you can see, you just draw some lines, and the tool automatically draws gradients from one line to another with those line colors. The areas in between that were connected with two colors were filled in with gradients instead! The tool took the colors of the line borders and painted the colors with the pre-defined gradient settings. Therefore the corners were simply filled in with only that one color. The borders of the canvas don't count as color. The two corners only had one color connected to those areas. I also recommend using a very small and constant brush size. The most important thing is that "Anti-Aliasing" is turned of, and that you use a completely opaque brush. It can quickly create gradients that are much complex and flexible than what the regular gradient tool could ever achieve. Let me give you a short, rough introduction to this tool so that we all have at least a basic understanding of what it does, before we look at how reference layers can come into play.Īlso, I think this tool can be quite convenient, so learning more about it is worth it in my opinion.īasically it paints gradients between lines that you drew beforehand on the same layer. It's called "Contour Line Paint", or also referred to as "Freeflow Gradient". Now here is a tool that is, as far as I can tell, a bit lesser known. Unfortunately it doesn't have a "Close Gap" option, unlike the Fill Tools or Auto Select. You just need to make sure that your brush stays within the lines, and it is a bit harder to work with if your line-art has gaps. So the "Do not cross lines of reference layer" setting can be incredibly useful and versatile! However, if you have some other stuff going on above or below, like textures, some background, shading, or such, then that would also get referred to by the Auto Select tool. You just need to switch between the tools, but not between the layers. If you only have your line and color layers, then it works pretty efficiently too. Now let's turn on "Refer Multiple", but set it to "All Layers". Go back to step 1 if you need to make new selections to work on other areas. Make your selections with the Auto Select Tool That would mean you would have to do the following steps in order the select areas and paint inside them: That means that the Auto Select will only refer to the layer you currently have selected. So, firstly let's keep "Refer Multiple" turned off. You will see that reference layers make that whole process much easier. Before I set up any reference layers though, I will show you how you would make the selections WITHOUT reference layers and compare the methods afterwards.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |